Command to enable ODR.
In global configuration
router odr
Example
R1 is a HUB. R2 and R3 are spoke routers. Note that we do not have any routing process on R3 and R2. R1 only have IP reachability to R2 and R3. Configuration is only done on R1.
Configuration
R1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#router odr
R1(config)#router odr
R1(config-router)#
Verify Configuration
R1#sh ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is not set
1.0.0.0/32 is subnetted, 1 subnets
o 1.1.1.1 [160/1] via 192.168.1.2, 00:00:01, FastEthernet0/0
2.0.0.0/32 is subnetted, 1 subnets
o 2.2.2.2 [160/1] via 192.168.2.2, 00:00:35, FastEthernet0/1
C 192.168.1.0/24 is directly connected, FastEthernet0/0
C 192.168.2.0/24 is directly connected, FastEthernet0/1
R1#
Spoke Routing table
R2#sh ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is 192.168.2.1 to network 0.0.0.0
2.0.0.0/32 is subnetted, 1 subnets
C 2.2.2.2 is directly connected, Loopback1
C 192.168.2.0/24 is directly connected, FastEthernet0/0
o* 0.0.0.0/0 [160/1] via 192.168.2.1, 00:00:48, FastEthernet0/0
No comments:
Post a Comment