PPPoFR

Sample Configuration of PPPoFR

Configuration
R1 and R2 are connected via Frame relay network. We now configure PPPoFR with the network 192.168.1.0/24 as below.

R1
!
interface Serial1/0
 no ip address
 encapsulation frame-relay
 serial restart-delay 0
 frame-relay interface-dlci 102 ppp Virtual-Template10
end
!

interface Virtual-Template10
 ip address 192.168.1.1 255.255.255.0

R2

interface Serial1/0

 no ip address

 encapsulation frame-relay

 no fair-queue

 serial restart-delay 0

 frame-relay interface-dlci 201 ppp Virtual-Template10

!

interface Virtual-Template10

 ip address 192.168.1.2 255.255.255.0

!

Verify configuration



R1#sh ip int brief
Interface                  IP-Address      OK? Method Status                Protocol
FastEthernet0/0            unassigned      YES unset  administratively down down
FastEthernet0/1            unassigned      YES unset  administratively down down
Serial1/0                  unassigned      YES unset  up                    up
Serial1/1                  unassigned      YES unset  administratively down down
Serial1/2                  unassigned      YES unset  administratively down down
Serial1/3                  unassigned      YES unset  administratively down down
Virtual-Access1            unassigned      YES unset  down                  down
Virtual-Access2            192.168.1.1     YES TFTP   up                    up
Virtual-Template10         192.168.1.1     YES manual down                  down

R1#sh int virtual-access2
Virtual-Access2 is up, line protocol is up
  Hardware is Virtual Access interface
  Internet address is 192.168.1.1/24
  MTU 1500 bytes, BW 100000 Kbit, DLY 100000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation PPP, LCP Open
  Open: IPCP
  PPPoFR vaccess, cloned from Virtual-Template10
  Vaccess status 0x44
  Bound to Serial1/0 DLCI 102, Cloned from Virtual-Template10, loopback not set
  Keepalive set (10 sec)
  DTR is pulsed for 5 seconds on reset
  Last input 00:00:02, output never, output hang never
  Last clearing of "show interface" counters 00:04:53
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     23 packets input, 364 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     51 packets output, 582 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions

R1# ping 192.168.1.2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/70/108 ms
R1#